Water hardness in Phoenix, AZ: is it hard, and do you need a softener

Phoenix's 2025 water report lists hardness of 172 to 302 ppm, or 10 to 17.6 grains per gallon. Here is what that means and when a softener makes sense.

Short answer: Yes, Phoenix water is hard. The City of Phoenix’s 2025 Water Quality Report lists total hardness of 172 to 302 ppm, or 10 to 17.6 grains per gallon. On the USGS scale that is hard to very hard.

The Phoenix hardness figure, straight from the city

The figure comes from the table titled “2025 Aesthetic Water Quality Analysis from Distribution System & Secondary Drinking Water Guidelines” in the city’s annual report:

Total Hardness | ppm; grains/gallon | NA | 172 - 302 / 10 - 17.6

  • Source: City of Phoenix Water Services Department, 2025 Water Quality Report (PDF on phoenix.gov)
  • Figure: 172 to 302 ppm, or 10 to 17.6 grains per gallon (range of distribution system samples, no average given)
  • Report year: 2025
  • Accessed: November 18, 2026

“NA” means there is no EPA secondary guideline for hardness. The report says: “Taste, odor and hardness are not regulated under drinking water health standards. However, these are harmless, aesthetic aspects that some consumers may notice.”

Phoenix hardness in grains per gallon (the math)

Water reports use ppm, which is the same as mg/L. Softeners use grains per gallon (gpg). The conversion is 17.1 mg/L = 1 grain per gallon.

ppm (mg/L) Math Our result City’s printed gpg
Low end 172 172 ÷ 17.1 10.1 gpg 10
High end 302 302 ÷ 17.1 17.7 gpg 17.6

Our math lands within about 0.1 grain of the city’s printed figures. The small gap is rounding or a slightly different conversion factor. Use the city’s figures, 10 to 17.6 gpg, when you talk to a softener installer.

Is that hard? The USGS scale

The U.S. Geological Survey classifies hardness this way (USGS Water Science School, “Hardness of Water”, accessed November 18, 2026):

USGS class mg/L as calcium carbonate
Soft 0 to 60
Moderately hard 61 to 120
Hard 121 to 180
Very hard more than 180

The low end of Phoenix’s range (172 ppm) is hard. Most of the range, up to 302 ppm, is very hard.

Why Phoenix water is hard

The city’s report says hardness comes from minerals like calcium and magnesium that “originate from the soils our source water contacts as it travels to Phoenix’s water treatment plants.” The same report says that in 2025, about 97 to 99 percent of Phoenix’s water was surface water, mainly from the Salt, Verde, and Colorado rivers. The remainder came from about 20 city-operated groundwater wells.

The city gives one system-wide range, not a figure by ZIP code or treatment plant. Your own tap could be anywhere in that range. If your water bill comes from a different city or utility, check that utility’s own report instead.

What 10 to 17.6 gpg usually means at home

The city’s report itself says: “Hard water can cause some types of scaling in pipes and water heaters, and on plumbing fixtures such as faucets and showerheads.” At home, that usually looks like:

  • White crust on faucets, showerheads, and shower glass
  • Scale in kettles, coffee makers, and water heaters
  • Spots on dishes and glasses after the dishwasher

This page makes no health claims. The city describes hardness as aesthetic.

What to do: when cleaning is enough, and when a softener makes sense

Cleaning is often enough if you rent, your test reads near the low end (about 10 gpg), or the problem is mainly spots on glass and fixtures:

  • Soak showerheads and aerators in white vinegar
  • Wipe shower glass after use, and clean scale with vinegar weekly
  • Descale your kettle, coffee maker, and dishwasher per their manuals
  • Flush your water heater as its manual recommends

A softener makes more sense if:

  • You own the home and your tap tests toward the high end of the range
  • Scale comes back within days, or your water heater or tankless unit keeps scaling
  • You want to reduce fixture and appliance scale long term and are fine with salt refills and regeneration

Test first. The city range is system-wide. Measure your own tap in grains per gallon before anyone quotes you a system.

Sizing: a softener should be sized to your measured hardness and your household’s water use. Ask any installer to show the math in writing.

About shower filters: most are sold to reduce chlorine. Check the product’s own spec sheet before assuming it does anything about hardness.

About home treatment in general, the city’s report warns: “failure to follow the manufacturer’s instructions concerning operation and maintenance can result in potentially unsafe water.” It points readers to the Water Quality Association at wqa.org for more on home treatment systems.

Read the report yourself

Want to check the numbers? Our guide walks through a water report in ten minutes: How to read your city water quality report (CCR).

Sources

  1. City of Phoenix Water Services Department, 2025 Water Quality Report, “2025 Aesthetic Water Quality Analysis from Distribution System & Secondary Drinking Water Guidelines” table, plus the “Taste, Odor and Hardness” and “Where Does Our Water Come From?” sections. PDF. Accessed November 18, 2026.
  2. City of Phoenix, Water Quality Reports archive. phoenix.gov. Accessed November 18, 2026.
  3. U.S. Geological Survey, Water Science School, “Hardness of Water.” usgs.gov. Accessed November 18, 2026.

Questions

How hard is Phoenix tap water?

The City of Phoenix 2025 Water Quality Report lists total hardness of 172 to 302 ppm, which the city also gives as 10 to 17.6 grains per gallon.

Is Phoenix water hard or very hard?

On the USGS scale, 172 mg/L is hard and 302 mg/L is very hard, so Phoenix water ranges from hard to very hard depending on the sample.

Is hard water in Phoenix a health problem?

The City of Phoenix report says taste, odor, and hardness are not regulated under drinking water health standards and calls them harmless, aesthetic aspects.

Do I need a water softener in Phoenix?

Many Phoenix homes do consider one, because the city range reaches 17.6 grains per gallon. Test your own tap first, and size any softener to your measured number and water use.

Published November 18, 2026 · Updated November 18, 2026.